Unshaped Refractories / Coil Coat & Patching Material
CUMI SUPER SHIELD Coil Coat & Patching Material
CUMI SUPER SHIELD is the 94.0% min Al₂O₃ grade in Shanker Agencies’ coil coat & patching material range, rated for continuous service to 1800°C.
CUMI SUPER SHIELD technical specification
Typical values for CUMI SUPER SHIELD coil coat & patching material. Test methods vary by property and product family, so confirm the applicable standard against the manufacturer datasheet before specifying.
Where CUMI SUPER SHIELD is used
Is CUMI SUPER SHIELD right for your application?
- Rated for continuous service up to 1800°C.
Compare CUMI SUPER SHIELD with other grades▾
Compare CUMI SUPER SHIELD against every grade SAPL stocks in this family.
Swipe to compare grades
| Grade | Al₂O₃ content | Bulk density | Cold crushing strength | Application | Max service temperature |
|---|---|---|---|---|---|
| CUMI SUPER SHIELDthis grade | 94.0% min | 2.60 g/cc min (dried 110°C) | 200 kg/cm² min (dried 110°C) | Coil coating castable | 1800°C |
| CUMI SHIELD | 87–90% | 2.50 g/cc min (dried 110°C) | 250 kg/cm² min dried; 550 min fired 1450°C | Coil coating castable | 1700°C |
| HeatKing CA 337 | 91.4% | 2.67 g/cm³ (cast & dried) | — | Coil coat / coil grout | 1750°C |
| HeatKing PA 748 | 83% | — | 17 MPa min (fired 1250°C) | Patching / primer / undercoat | 1760°C |
Send the drawing, dimensions, application and quantity for CUMI SUPER SHIELD coil coat & patching material. Our technical team reviews the requirement and advises on grade and fulfilment route.
Request CUMI SUPER SHIELD QuoteGrade designations & equivalents▾
How CUMI SUPER SHIELD is referenced across Indian and export naming conventions.
| SAPL grade code | CUMI SUPER SHIELD |
| Alumina content | 94.0% min Al₂O₃ |
| Max service temperature | 1800°C |
Installation notes
- 1CA 337: mix with approximately 10–12% water and apply as coil grout over the coil before the working lining is rammed
- 2CA 337: allow the coat to dry fully before ramming the working lining against it
- 3PA 748: mix 7.8–10 litres of clean water per 25 kg bag, adjusting for water temperature, ambient conditions and required working time
- 4PA 748: apply to a cleaned, sound surface as a primer or undercoat, then build up the patch
- 5Both are hygroscopic, store in a cool dry place and keep bags sealed until use
- 6Follow the manufacturer’s heat-up schedule; do not return the furnace to full power before the patch has dried through
Disclaimer: values are typical and compiled by Shanker Agencies Pvt. Ltd. from standard industry data and published manufacturer specifications. They are indicative, not a guarantee. Confirm the exact grade datasheet before specifying. For a certified datasheet or quotation, contact info@shankeragencies.com or +91 98999 57888.